7m Paint Chamber Garage Spray Booth Heat Recuperation Rock Wool
Panel Siemens Motor
1. With heat recuperation system, energy save and more efficiency.
2. 0.6mm coated steel with rock wool inside for wall panel.
3. Quality brand name turbo fans, directly drive type
4. Riello RG5S diesel burner with a heating productivity of
5. Pneumatic damper for spraying to baking cycle.
6. Double layer heat exchanger.
7. Siemens motors.
8. Electric damper for intake and exhaust, control the air flow.
In painting, outside fresh air comes into the heating generators
through the pre-filter system, and enters into the plenum, then
filtered by ceiling filter and into the both which brings clean,
symmetrical and steady-going down airflow for spraying,After
painting, Hot air goes from heating
generators to plenum, then enters room after filtered by ceiling
filter, providing heat that is necessary for baking of cars
surface. In the meantime, heat recuperation system start
working,energy save and temperature raise fast. Afterwards, the air
with little benzene will be released to the atmosphere after being
filtered twice by the exhaust air filter.
|Inside dimension||7000×4000×2800 mm (L×W×H)|
|Outside dimension||7120×5520×3750mm (L×W×H)|
|Front door||Folding door, 3 folds, 3000×2750 mm (W×H), without frame, square
window frame, orange colour, door head and two batten on both sides
white colour, with safety escape door lock.|
|Emergency door||1 units, 800×2000mm (W×H), colour: white, with safety escape door
|Basement||Galvanized steel assemble, 350mm high, galvanized steel bending
support, full grilles made by flat bar 30×5 and twisted steel,
galvanized, 3 ramps, 900×2500mm/pc, silver colour.|
|Wall panel||Thickness: 60mm, both sides covered by coated steel, thickness
0.6mm, with rock wool inside, colour: white.|
|Light||Ceiling Lights: 8Units×4Pcs=32Pcs×36W, both sides lights:
7Units×4Pcs=28Pcs×36W, back side lights: 4Units×4Pcs=16Pcs×36W, LED
|Generator cabinet||Intake from back upper, exhaust from rear upper, galvanized steel
frame; white powder coated panel covered, filled with heat
preservation material PU inside.|
|Intake and Exhaust system||Inlet: 1×7.5KW turbo fan, Siemens motor, air capacity for each fan:
25000m3/h, electric damper.|
|Outlet: 1×7.5KW turbo fan, Siemens motor, air capacity for each
fan: 25000m3/h, electric damper.|
|Heating system||Italy RIELLO RG5S diesel burner, double layer stainless steel heat
exchanger, pneumatic damper actuates from spraying to baking cycle.
Max. heating productivity: 260000kcal/h, with heat recovery system.|
|Purification system||Pre-filter (pocket type), ceiling filter, fibreglass filter,
activated carbon filter (pocket type)|
|Roof||50mm rock wool panel.|
|Control system||Spraying, heat spraying, baking, time setting, lighting switch,
failure indicator, thermostat, power supply switch, emergency stop,
pressure gauge, all motors reduced-voltage starting.|
|Total power||17KW (Power supply 1×220V, 3×380V, 50HZ)|