High Precision Garage Outdoor Spray Booth Combined Pneumatic Ramp
1, 7.5KW turbo fan for intake, 7.5KW turbo fan for extraction.
2, Inner pneumatic ramps for space limited.
3. Air units at back side.
4, Two sets side by side, with PVC curtain in the middle.
5, All LED lights, energy save and more illumination.
6, Color white, blue, orange and red is optional.
7, Grilles in the central.
8, Full down draft.
Special for the space limited, put the ramps inside, shorten the
booth length, air flow from back side, intake and suction units
from complete basement, full down draft, two units side by side,
option for the electric shutter door between two spray booth, and
rail on the floor, car moveable from one booth to another.
In painting, outside fresh air comes into the heating generators
through the pre-filter system, and enters into the plenum, then
filtered by ceiling filter and into the both which brings clean,
symmetrical and steady-going down airflow for spraying, After
painting, hot air goes from heating
generators to plenum, then enters room after filtered by ceiling
filter, providing heat that is necessary for baking of cars
Specification as below for one unit only.
|Inside dimension||6900×3900×2650 mm (L×W×H) for one side only|
|Outside dimension||8500×4000×3400mm (L×W×H) for one side only|
|Front door||Folding door, 3 folds, 3000×2600 mm (W×H), without frame, aluminium
alloy window frame, orange colour, door head and two batten on both
sides white colour.|
|Emergency door||1 units, 650×1800mm (W×H), colour: white.|
|Basement||Galvanized steel assemble, 300mm high, quadrate steel support,
Central grilles made by flat bar and twisted steel, inner pneumatic
|Wall panel||Thickness: 50mm, width:1150mm, tongue and groove structure, 0.376mm
colour steel with EPS inside, colour: white, PVC curtain in the
middle separate to two position.|
|Light||Ceiling Lights: 8Units×4Pcs=32Pcs×16W, side lights:
8Units×2Pcs=16Pcs×7W, with LED, lighting boxes are powered coated,
|Generator cabinet||Intake from back upper, exhaust from rear upper, galvanized steel
frame; orange machine-made panel covered, filled with heat
preservation material inside.|
|Intake and Exhaust system||Inlet:1×7.5KW turbo fan, air capacity for each fan: 25000m3/h.|
|Outlet: 1×7.5KW turbo fan, air capacity for each fan: 25000m3/h.
Manual damper, 4m ducts, 1 pcs 900 bend, 1 pcs 300 bend.|
|Heating system||Italy RIELLO G20 diesel burner, stainless steel heat exchanger,
pneumatic damper actuates from spraying to baking cycle. Max.
heating productivity: 200000kcal/h, max temperature: 80℃, 4pcs
chimney, 1 pcs bend.|
|Purification system||Pre-filter, ceiling filter, fibreglass filter, activated carbon
|Control system||Spraying, heat spraying, baking, time setting, lighting switch,
failure indicator, thermostat, power supply switch, emergency stop,
all motors is normal start.|
|Total power||16KW (Power supply 1×220V, 3×380V, 50HZ)|