7M Custom Industrial Paint Booth Equipment Riello G20 Burner
1, 7.5KW turbo fan for intake, 7.5KW turbo fan for extraction.
2. All panels are tongue and groove interlock structure.
3, #304 stainless steel heat exchanger.
4, All LED lights, energy save and more illumination.
5, Color white, blue, orange and red is optional.
6, OEM available.
In painting, outside fresh air comes into the heating generators
through the pre-filter system, and enters into the plenum, then
filtered by ceiling filter and into the both which brings clean,
symmetrical and steady-going down airflow for spraying,After
painting, Hot air goes from heating
generators to plenum, then enters room after filtered by ceiling
filter, providing heat that is necessary for baking of cars
surface, hot air recycling until the temperature up to setting
valve. Afterwards, the air with little benzene will be released to
the atmosphere after being filtered by the air filter.
|Inside dimension||6900×3900×2650 mm (L×W×H)|
|Outside dimension||7000×5350×3400mm (L×W×H)|
|Front door||Folding door, 3 folds, 3000×2600 mm (W×H), without frame, aluminium
alloy window frame, orange colour, door head and two batten on both
sides white colour.|
|Emergency door||1 units, 650×1800mm (W×H), colour: white.|
|Basement||Galvanized steel assemble, 300mm high, quadrate steel support, full
grilles made by flat bar and twisted steel, 2 ramps, 750×2000mm/pc,
|Wall panel||Thickness: 50mm, width:1150mm, tongue and groove structure, 0.376mm
colour steel with EPS inside, colour: white.|
|Light||Ceiling Lights: 8Units×4Pcs=32Pcs×18W, side lights:
8Units×2Pcs=16Pcs×18W, with LED, lighting boxes are powered coated,
|Generator cabinet||Intake from back upper, exhaust from rear upper, galvanized steel
frame; orange machine-made panel covered, filled with heat
preservation material inside.|
|Intake and Exhaust system||Inlet:1×7.5KW turbo fan, air capacity for each fan: 25000m3/h.|
|Outlet: 1×7.5KW turbo fan, air capacity for each fan: 25000m3/h.
Manual damper, 4m ducts, 1 pcs 900 bend, 1 pcs 300 bend.|
|Heating system||Italy RIELLO G20 diesel burner, stainless steel heat exchanger,
pneumatic damper actuates from spraying to baking cycle. Max.
heating productivity: 200000kcal/h, max temperature: 80℃, 4pcs
chimney, 1 pcs bend.|
|Purification system||Pre-filter, ceiling filter, fibreglass filter, activated carbon
|Control system||Spraying, heat spraying, baking, time setting, lighting switch,
failure indicator, thermostat, power supply switch, emergency stop,
all motors is normal start.|
|Total power||17.5KW (Power supply 1×220V, 3×380V, 50HZ)|