Commercial Car Sanding Paint Prep Station 7550×3550×3100MM Outside
Bright full booth illumination is provided by eight (8) four-tube,
LED light fixtures in the ceiling panels and both sides panel. PVC
curtain in the middle to separate the job in different position.
Moveable infrared on the ceiling flexible for baking small surface,
more efficiency and energy save, pneumatic inner ramps can be
raised after car go inside, to save the space.
1. One 5.5kw for intake and exhaust, two unit connected.
2. Quality brand turbo fans, directly drive type.
3. Heating system infrared.
4. Down draft air flow.
5. Steel basement with grilles in the middle.
6, Pneumatic inner ramps, more efficiency and space save.
Prep station used for making base coat, top coat, sanding and small
painting, outside fresh air comes into the booth through the
ceiling filter system, from the plenum, down air flow comes out,
and extraction from full grilles directly through fibreglass filter
and carbon filter, the air flow can be control by electric damper.
easy for installation and maintenance, the most importance things
is the cost very low, highly cost effective, more efficiency as the
moveable infrared and inner ramps.
Below for one unit only:
|Inside dimension||6300×3450×2650 mm (L×W×H)|
|Outside dimension||7550×3550×3100mm (L×W×H)|
|Plenum dimension||6300×3450×450 mm (L×W×H)|
|Steel basement||Steel basement, 300mm high, grilles in the middle, twisted steel
grilles, painted, pneumatic ramps, can be raised after car going
|Room body||Back side 50mm EPS wall panel, the other sides PVC curtain.|
|Light||Ceiling Lights: 8Units×4Pcs=32Pcs×16W, side light:
8Units×4Pcs=32Pcs×7W with LED, lighting boxes are powered coated.|
|Generator cabinet||Exhaust from back side, galvanized steel frame; white machine-made
panel covered, filled with heat preservation material inside.|
|Intake and Exhaust system||1×5.5KW turbo fan, air capacity: 18000m3/h, with electric damper.|
|Purification system||Pre-filter, ceiling filter, fibreglass filter.|
|Control system||Fan switch, lighting switch, emergency stop.|
|Installs way||Hooked from roof by steel cable or supported by steel column.|
|Total power||6.7KW (Power supply 1×220V, 3×380V, 50HZ)|